CD Lable Text

After finishing the DVD Case Cover, I'll now move on to creating the DVD Lable for the disk.

I'll be using the template for the DVD I created before, and will first be applying the text I created in Illustrator to it.

I opened the project where I first created the text and the template project and copied the text over. The text was far too large for the DVD, so while holding down Shift I dragged the corner Select point of the text and made it smaller. Holding shift means it will keep its scale.

Here is the text on the template and scalled to fit within it. However the stoke effects have no scalled, with it and so are very large.


To alter the size of the stroke effects I go either to the stroke tab on the side.

or the stroke at the top.

Both while having the text selected. I'll then make the stroke smaller.


I placed the text lower down below the DVD center hole so the whole text could be seen, I also made it smaller so it can all fit.